Document types

You must be using the Corporate Site template. Go into the repeater you are attempting to load your new doc types in and in the Transformation property, select the correct transformation. I'm guessing it would be something like custom.AirCompressor.Default

Hello,

I want more explain your solution, sorry but I'm new in kentico..

Awaiting...

For more details please check this link: http://www.namerah.com/Products/Air-Compressors/Piston-Compressor-N300.aspx

I understand the error, what you need to do is go to your custom.aircompressor doc type and look at the transformations, I'm guessing there isn't one there named "CorporateSite". In the repeater on that page or template you need to modify that Transformation property to a value of a transformation that exists in the aircompressor doc type.

Hello,

This is correct, I don't see the CorporateSite Transformation.

Now I need to explain that you said:((In the repeater on that page or template you need to modify that Transformation property to a value of a transformation that exists in the aircompressor doc type))

Where can I do this modify?

Please advise..

Awaiting.....

Create the transformation you want in that aircompressor doc type, then go to the page and click the design tab and select "configure" the repeater webpart on the page and select the transformation you just created for the transformation property. These are some basics of Kentico, you might want to read up on how Kentico works and what it offers.

Hello,

Do you mean I should to write the codes when I create new transformation? If yes, I'm new in kebtico how can I create this codes? If there any easy steps to do that.

Thank you.

Do you have any sulotion to use custome type without write the code?

Hi,

1. edit your custom custom.aircompressor document type.
2. On Transformations tab click on New transformation button.
3. Click on Generate default transformation button.
4. Save transformation.

Now you should not see the error on your site.

To see more transformation examples click on Available transformation methods link on Transformations tab.

Best regards,

Ivana Tomanickova