Forums (Obsolete)

Old Forums

Installation and deployment Questions on installation, system configuration and deployment to the live server.

Version 6.x > Installation and deployment > Using the New Site Wizard in Site Manager

View modes:

Member

srbarry-gmail - 1/30/2012 1:09:48 PM

Using the New Site Wizard in Site Manager

I'm trying out the 30 day trial for KenticoCMS and I'm trying to understand the point of the New Site Wizard in the Site Manager. It seems that I cannot create a new Site using a different port than what was used when I first created a Kentico site using IIS. I can only create another site on the same port and have to stop the first site to work on the new site. This is not the case when I use Visual Studio's built in web server though. Is there something I'm doing wrong or this is an expected behavior. If I wanted to create multiple sites how would I go about doing that?


Member	barry - 1/31/2012 7:55:56 AM RE:Using the New Site Wizard in Site Manager Correction to my first post. I have the same results for visual studio's web server too. Site Manager will list the new site but I cannot browse the site - "IE cannot display the web page"

Kentico Support

kentico_radekm - 2/4/2012 3:17:38 PM

RE:Using the New Site Wizard in Site Manager

Hello.

Purpose of New site wizard is to install pre-defined web template. Domain name is another problem, it assumes that you have some valid license for your domain. Allowed port number (usually 80) depends on IIS settings, this is property of IIS web site (Advanced settings / Bindings). If you need to run another site within a single instance and have problem with port number, you can generate Free license key for any required domain name, or send us license key request to support@kentico.com.

Best Regards,
Radek Macalik

Top